The RMS Electromagnetic Flowmeters, with no moving parts and an obstruction- less bore, offer the highest level of performance, unaffected by specific gravity or viscosity variations, or the most contaminated of fluids, whilst maintaining a high degree of accuracy for liquid flow Measurement.

Application examples include use in tradewaste, water-based admixtures, recycle /slurry water batching in readymixed concrete plants, bulk chemical delivery tanker loading and transfers, and pharmaceutical and metalurgical applications.

Almost any liquid can be measured (which has a conductivity of at least 5 microsiemens) to an accuracy of ± 0.5% of reading, and over a very wide flow range.

The RMS range of Electromagnetic Flowmeters is available in standard sizes from 4mm to 150mm diameter, with a standard integral wafer mount cast iron sensing tube lined in standard ETFE Tefzel, with stainless steel electrodes.

The IP66-rated transmitter housing is integrally head mounted to the sensor tube (standard), or remotely connected by a low voltage cable.

Power is 90-250 VA (standard), or optional 15-50 VDC. Units are fully programmed and wet tested.

Standard features are pulse output, 4-20mA output, empty pipe indication and Hart Communication.

Optionally, a M4 (LOI) Flowrate Totaliser display module can be fitted for visual process indication, and to allow reprogramming. Other options include different liner /

electrode materials and remote mounted transmitters.

The units can also optionally be fitted with mounting pipe flanges and earthing rings and be electrically wired. This fit out allows for even easier installation and commissioning.

Leave a Reply

Your email address will not be published. Required fields are marked *